Epson EPL N2700 Service Manual page 39

EPL-N2700
LC1 to LC3 Type
These are basically same as the MP Type but because special paper
cannot be fed from the LC1 - LC3, "Letterhead", "Bond", "Transprnc",
and "Labels" can not be selected.
Paper Source
The priority for selecting the paper source is in the order of MP Tray >
LC1 > LC2 > LC3. (Applicable when "MP Tray Mode" is set to "Normal".)
The combination of the optional paper sources and the name during the
selection is as shown in the below:
Table 1-29. Combination of the Optional Paper Cassette and
Corresponding Names
MP Tray LC1 LC2
Standard Standard ---
500-sheet
Standard Standard
cassette unit
500-sheet
Standard Standard
cassette unit
Standard Standard LCC *
500-sheet
Standard Standard
cassette unit
*: Large Capacity Lower Cassette
Multibin
The values that can be selected for the "Out Bin" in the "Printing Menu"
vary depending on the selection made for the "Multibin" in "Setup Menu"
as shown in the following table:
Product Description
LC3 Remarks
--- No option installed
One 500-sheet cassette
---
unit installed
500-sheet Two 500-sheet cassette
cassette unit units installed
--- LCC installed
One 500-sheet cassette
LCC *
unit and LCC installed
Panel Operation
Table 1-30.
"Multibin" Settings and Corresponding Outbins Available
Mailbox Sorter
Without option Face-down Face-down
Face-down,
Face-down,
5-bin unit Mailbox 1,
Sorter
Mailbox 2 - 5
Face-down,
Face-down,
10-bin unit Mailbox 1,
Sorter
Mailbox 2 - 10
NOTES:
1. When an optional unit is installed, the standard Face-down can no be used. So,
"Face-down" in this case means another device.
2. If any item which can not be selected due to operation mode of the Outbin is
selected by the EJL or ESC/Page command, the selection is ignored,
3. If Face-down is selected in the 5-bin or 10-bin mailbox mode, paper is output to
Mailbox 1.
Output Tray Selection Specifications
<5-bin unit>


When "Multibin = Stacker" and "Outbin = Stacker" are selected:

The sequence of outbin destinations is Bin2 > Bin3 > ---> Bin 5 >
Bin1.

The printer searches some consecutive empty bins in the order
of Bin 5 - Bin 2, and paper will be output to the empty bin which
found last in the search.
<10-bin unit>


When "Multibin = Stacker" and "Outbin = Stacker" are selected:

The sequence of outbin destinations is Bin10 > Bin9 > ---> Bin 2
> Bin1
Revision A
Multisort Stacker
Face-down Face-down
Face-down, Face-down,
Sorter Stacker
Face-down, Face-down,
Sorter Stacker
39