Epson EPL N2700 Service Manual page 116

EPSON EPL-N2700
9. Remove one screw (1305) securing the Heater Lamp Holder (front)
to the Fuser Unit Frame Assembly and remove the Heater Lamp
Holder and Heater Lamp. (See Section 4.2.21.2.)
10. Remove one E-ring (9107) fixing the Fuser Unit Cover to the
shoulder screw on the rear frame of the User Unit. Then release the
Fuser Unit Cover from the shoulder screws on the right and left
frame of the Fuser Unit.
Chapter 4 Disassembly/Assembly
Figure 4-43. Upper Paper Separator Finger Assembly Removal
11. Remove the shoulder screws securing the right and left levers to the
front and rear frames in the Fuser Unit, and remove the levers along
with the torsion spring, spacers and Front Guide Plate.
12. Remove two screws (1305) securing the Upper Paper Separator
Finger Assembly to the front and rear frames in the Fuser Unit and
remove the Upper Paper Separator Finger Assembly.
Rev. A
116