Sony Handycam HDR-FX1 Operating Instructions Manual page 84

Symptom Cause and/or Corrective Actions
The CHG (charge)lamp flashes while -)'Attach tile battely" pack to tile camcorder conectly. It'tIle problenl
the batte!), pack is being charged, persists, discmmect the AC Adaptor fronl tile wall outlet and contact
your Sony dealer The barre!), pack may be damaged (p 11, 93).
The battely pack is not charged -> Set tile POWER switch to OFF (CHG).
The battery pack is quickly • The tempelamre of the environment is too low, or the battery pack has
discharged, not been charged enough This is not a malfimction.
->Fully charge the batte!), again If tile problem persists, replace the
battery pack with a new one It may be damaged (p. 11, 93).
The remaining barrels" time indicator • The tempemttue of the environment is too high or too low, or tile battely
does not indicate the correct time. pack has not been charged enough. This is not a malfilncfion.
->Fully charge the batte! 7 again If tile probleln persists, replace the
batWry pack with a new one It may be damaged (p. 11, 93).
The powe! turns off fiequently • A problem has occuned in the remaining battery time indicator, or tile
although the remaining batwry battelw pack has not been charged enough.
indicator indicates that tile battery ->Fully charge the batte! 7 again to CO1Tect tile indication (p. 11)
,ack has enough power to operate.
A problem occurs when the -> Turn off tile power, and disconnect the AC Adaptor from the wall outlet.
camcorder is connected to the AC Then, connect it again.
Adaptor
Symptom Cause and/or Corrective Actions
Cassette cannot be ejected from the ">Make sure tile power source (battery pack or AC Adaptor) is connected
compaltment correctly (p. 11).
-'1Remove tile barrel 3, pack from the camcorder, then attach it again (p. 11 )
->Attach a charged battery pack to the camcorder (p 11)
Cassette is not ejected even when tile ->Moisture condensation is starting in yolu camcordel (p 95).
cassette lid is open.
The Cassette Memory indicator does -> Since your camcorde! is not compatible with the Cassette Memory, no
not appear while using a cassette with indicator appears.
Cassette Memory
The remaining tape indicator is not -'1Set [ [] REMAINING] to [ON] on the _ (OTHERS) menu to always
displayed, display the remaining tape indicator (p. 64).
84 Troubleshooting