Sony Handycam HDR-FX1 Operating Instructions Manual page 48

When you have an S video jack
TV or VCR
Component video cable (supp_dt ........
_AUDIO
II COMPONENT
[ VIDEO IN
PB/CB
Signal flow
Connect your camcorder and your TV or
VCR using either cables described below.
To connect the TV using the component
video cable
This connection is recommended when your TV
has COMPONENT VIDEO jacks.
• To view the picture recorded in the HDV
fomlat, set [COMPONENT] on the _ (IN/
OUT REC) menu according to yotLr TV
(p. 60). When a picture recorded in the DV
fomaat is played back, an eqnivalent signal
with [480i] is output, even if [1080i/480i] is
selected.
• Only video signals are output from the
COMPONENT OUTPUT jack. To output
audio signals, connect the white and red plugs
of the AV connecting cable to the audio input
jack of your TV or VCR.
To connect the TV using the A/V
connecting cable
When there is an S video .jack on the device to
be connected, connect it with your camcorder
by the S video jacks using an S video cable
(optional) instead of the yellow video plug of
the AiV connecting cable (snpplied). Use an S
video cable to produce high resolution pictures.
The audio will not be output when you connect
with the S video cable alone.
To view the picture on a 4:3 IV
• To view the picture recorded in the HDV
l)rmat, select the _ (IN/OUT RE() menu,
[TV TYPE], then [4:3[ (p. 61).
• To view the pictnre recorded in the DV
l_rmat, select the _* (CAMERA SET)
menu, [DV WIDE REC], then [OFF[ before
recording (p. 40).
48 Playback