EPSON Stylus Color 600 Service Manual
3.2.5.8
PE Sensor Assembly Removal
1. Removing the upper housing. (Refer to section 3.2.1)
2. From the front side of the mechanism, unhook two hooks fixing "SENSOR, ASSEMBLY, PE" to the
3. mechanism. Then, slide it to upward to remove it. After removal, disassemble the assembly if
necessary.
When re-install the assembly, be sure that the sensor lever is correctly inserted into a hole of "PAPER
GUIDE, ASSEMBLY", UPPER".
3-26
WORK POINT
Figure 3-24. PE Sensor Assembly Removal
Rev. A