Adjust Lever Settings (Pg Adjust Lever) - Epson 440 Service Manual

EPSON Stylus Color 600
1.2.3

Adjust Lever Settings (PG adjust lever)

The adjust lever located on the right side (blue knob) under the printer cover needs to be set to the
proper position according to the paper you print (Refer to the table below). Also, if there is any dirt
caused by friction on the wavy or wrinkled paper, this can be prevented by changing the lever position to
rear position (marked with "+") in spite of paper types.
Paper
Normal paper,
Coated paper
Transparency film
Label
Envelopes
1-6
Table 1-5. Adjust Lever Settings
Lever position
Front
Rear
Figure 1-2. Adjust Lever Settings
PG adjustment value
0 mm (1.1mm between head and platen)
0.9 mm (2.0mm between head and platen)
Rev. A