Epson 440 Service Manual page 129

No.
5 <Lubrication Point>
The shaft for "GEAR, 16, 40.8" at
"FRAME, LEFT"
<Lubricant Type> G-26
<Lubrication Amount>
Approx. 5mm long
6 <Lubrication Point>
Bush for "ROLER, PF"
1) Left: Inside the bush
2) Right: Inside the bush (near the
pump assembly)
<Lubricant Type> G-26
<Lubrication Amount>
Approx. 3mm diametrically
7 <Lubrication Point>
Both Left/Right Bush for "ROLLER, EXIT"
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply inside the bush
8 <Lubrication Point>
Contact between "HOLDER, PULLEY,
DRIVEN" and "FRAME, UPPER"
<Lubricant Type> G-26
<Lubrication Amount>
2mm long at each specified point
9 <Lubrication Point>
ASF;
A round hole of the right frame of ASF (to
hold the roller shaft)
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply inside the hole
10 <Lubrication Point>
ASF;
Contact between
"LEVER, HOPPER, RELEASE"
<Lubricant Type> G-26
<Lubrication Amount>
Evenly apply to the contact
Rev. A
Table 6-3. Lubrication Points (Continued)
Standard
"HOPPER" and
Remarks


Use a syringe to apply it.


When applying to the right bush, apply it
from the side of the paper path and wipe
off any grease stick out to the cap
assembly side.


Rotate "ROLLER, PF" after applying the
grease to evenly distribute it in the bush.


Use a syringe to apply it.


Do not put grease around the paper path.


Use a syringe to apply it.


Verify that the holder slides only with a
spring force after applying the grease.


Use a syringe to apply it.


Do not put grease to "ROLLER,
ASSEMBLY, LD".


Completely wipe off any grease stack out
to inner side of ASF.
Chapter 6 Maintenance
6-3