EPSON Stylus Color 600
1.4.2
Panel Functions
•q Panel Functions •r
Switch
Load/Eject
(Pushing within 0.5 seconds*)
Load/Eject
(Pushing for 2 seconds*)
Cleaning
(Pushing for 2 seconds*)
Cleaning
(Pushing within 2 seconds*)
Note) *: 3 seconds is required at the User's manual.
**: This function is not available in printing status.
***: The time to complete the sequence may vary depending on the printer's status.
•q Panel Functions with Power ON •r
Switch
Load/Eject
Cleaning
Load/Eject
+
Cleaning
Note) **: status printings prints firmware version, ink counter, selected code page and nozzle check
patterns.
•q Particular setting mode •r
Switch
Load/Eject
Note) ***: Refer to EEPROM map.
1-22
Table 1-19. Panel Function
Loads or Eject the paper.
When the carriage is on the Ink Cartridge change position, return the
carriage from Ink Cartridge change position.
Starts the Ink Cartridge change sequence.**
Moves the carriage to cartridge change position.
Starts the Head Cleaning sequence. ***
In the condition of "Ink Low" or "Ink Out" or "No Ink Cartridge" starts
the Ink Cartridge change sequence.**
When carriage is on the Ink Cartridge change position, return carriage
from Ink Cartridge change position.
Table 1-20. Panel Function with Power ON
Starts status printings.**
Enter the Default Setting mode
Enters the particular settings mode. (Factory use only.)
To enter the particular settings mode, it is necessary to push
followings switch while Paper Out LED is blinking.(It blinks about 5
seconds)
Table 1-21. Particular Setting Mode
Initialize EEPROM *** and reset Timer IC.
Function
Function
Function
Rev. A