Replacing The Modem Board - Gateway NV55 Service Manual

Replacing the modem board

Tools you need to complete this task:
Phillips #0 screwdriver
Flat screwdriver
Screws removed during this task:
•
1 black M2×5 (hard drive)
•
1 black M2.5×6 (optical drive)
•
3 black M2.5×6 (keyboard cover)
•
2 black M2.5×6 (LCD panel hinge - bottom)
•
2 black M2.5×6+Nylok (LCD panel hinge - top)
•
•
3 M2.5×6 black (palm rest - top side)
•
1 black M2×4 (modem board)
To replace the system board:
1
Complete the steps in
2
Complete the steps in
3
Remove the memory from the old system board and install it on the new
system board by following the instructions in the
memory modules"
4
If the notebook has a wireless card installed, remove the card from the old
system board and install it on the new system board by following the
instructions in the
5
Remove the hard drive by performing steps
hard drive" procedure on
6
Remove the optical drive by performing steps
optical drive" procedure on
7
Remove the palm rest by following steps
rest" procedure on
www.gateway.com
or Non-marring plastic scribe
10 M2.5×6 black (palm rest - base side)
"Preparing the notebook" on page
"Removing the battery" on page
section on page 50.
"Replacing the wireless card"
page 54.
page 56.
page 68.
47.
48.
"Adding or replacing
section on page
3 and 4 of the "Replacing the
3 and 4 of the "Replacing the
6–18 of the "Replacing the palm
52.
77