Replacing The Lcd Panel Assembly - Gateway NV55 Service Manual

Replacing the LCD panel assembly

64
CHAPTER 3: Replacing notebook components
Tools you need to complete this task:
Phillips #0 screwdriver
Flat screwdriver
Screws removed during this task:
•
3 black M2.5×6 (keyboard cover)
•
2 black M2.5×6 (LCD panel hinges - bottom)
•
2 black M2.5×6+Nylok (LCD panel hinges - top)
To replace the LCD panel assembly:
1
Complete the steps in
2
If the notebook has a wireless card installed, complete the steps in
"Removing the bay cover" on page
If there's no wireless card installed, proceed to
3
Remove the keyboard by performing steps
keyboard" procedure on
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
4
Turn the notebook over so the base is facing up.
5
Remove the base screws that secure the LCD panel hinges.
or Non-marring plastic scribe
"Preparing the notebook" on page
49, and then unplug the antenna cables.
page 62.
47.
step 5.
2–4 of the "Replacing the