Freemotion GYM User Manual page 6

2,
2
Remove the Shroud (not shown) from the back of
the weight system. (Note: The cover on the
Frame [1] is shown removed for clarity; the
cover cannot be removed.) Remove the four
indicated 1/4" x 2 1/2" Bolts (59) from the Frame.
Have a second person lift the Weight Guides (16)
and the Top Weight (15). Lubricate the inside of
the welded tubes on the Top Weight with the
included grease pack. Make sure that the two
Weight Bumpers (4) are placed over the indicated
holes in the bottom of the Frame (1).
Insert the two included dowels (not shown) into
the Weight Bumpers (4) and Frame (1). Slide the
five 20-Pound Weights (13) and the nine 10-
Pound Weights (14) onto the dowels. Note: Make
sure that the Weights are stacked in order so
that the lO-Pound Weight (14) marked "1 5" is
on top, and the 20-Pound Weight (13) marked
"15 100" is on the bottom.
Remove the dowels (not shown) from the stack of
Weights (13, 14). Insert the weight selector on the
Top Weight (15) and the two Weight Guides (16)
into the indicated holes in the Weights.
Secure the Weight Guides (16) to the Frame (1)
with the four 1/4" x 2 1/2" Bolts (59), the four
Weight Guide Spacers (5), and the four 1/4"
Nylon Locknuts (60).
Attach a Handle (9) to the Cable Eye (37) with a
Cable Clip (10). Attach the other Handle to the
other Cable Eye in the same manner.
Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
following page.
60
15-
Welded
Tube
Weight Selector
1
59
59
6