Enterasys VH-2402S Management Manual page 61

Port Assignment VLAN Configuration
Use this screen to configure port-specific settings for IEEE 802.1Q VLAN
features.
Unit ID : 1
Port ID : 1
Figure 2-40. Port Assignment VLAN Configuration
Parameter
PVID
802.1Q Trunk
Ingress Filter*
[Show]
[More]
* This control does not affect VLAN independent BPDU frames, such as GVRP or
STP. However, it does affect VLAN dependent BPDU frames, such as GMRP.
9033645-01
Vertical Horizon Local Management -- VH-2402S
Port Assignment VLAN Configuration
Unit Port PVID
--------------------------------------------------------------------------
1 1 3
1 2 3
1 3 1
1 4 1
1 5 1
1 6 1
1 7 1
1 8 1
1 9 1
1 10 1
[Show]
[More]
<APPLY>
Use <TAB> or arrow keys to move, <Space> to scroll options.
Description
The VLAN ID assigned to untagged frames received on this port.
Use the PVID to assign ports to the same untagged VLAN.
Used to enable/disable the VLAN trunk status for the port. A
VLAN Trunk link between two VLAN-aware switches will carry
traffic from all VLANs, allowing VLAN tagged frames to maintain
their VLAN ID across multiple switches. When enabled, a port
joins all configured VLANs and the untagged port VLAN ID
(PVID) is set to 4000, a reserved VLAN ID for trunk ports.
If set to "True," incoming frames for VLANs which do not include
this port in their member set will be discarded at the inbound port.
Displays settings for the specified stack unit and port.
Displays consecutively numbered stack units and ports.
802.1Q Trunk Ingress Filter
NO TRUE
NO TRUE
NO FALSE
NO FALSE
NO FALSE
NO FALSE
NO FALSE
NO FALSE
NO FALSE
NO FALSE
<OK> <CANCEL>
VH-2402S User Interface 53