Enterasys VH-2402S Management Manual page 48

You can use the Port Trunking Configuration screen set up port trunks as
shown below:
Trunk ID
------------- ------------- ---------------- ---------------- ---------------- ----------------
--
--
--
Trunk ID : 1
[Show]
[Enable]
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter
Trunk ID
Unit
Port
[Show]
[More]
[Enable] [Disable]
The RJ-45 ports used for each trunk must all be on the same internal
switch chip. The port groups permitted include:
Group 1
1,2,3,4,
13,14,15,16
Only two 100Mbps fiber ports can be configured as a trunk and these
must be on the same module. However, 1000Mbps fiber ports may be on
any module in the stack.
40 VH-2402S User Interface
Vertical Horizon Local Management -- VH-2402S
Port Trunking Configuration
Status
1
------------ Unit : -
Port : --
------------ Unit : -
Port : --
------------ Unit : -
Port : --
[More]
[Disable]
Figure 2-29. Port Trunking Configuration
Description
Configure up to three trunks per switch.
Specifies a switch unit in the stack (1~7).
Select from 2~4 ports per trunk.
Displays trunk settings, where the first trunk listed is specified by
"Sorted by Trunk ID."
Scrolls through the list of configured trunks.
Enables/disables the selected trunk.
Member List
2
Unit : -
Port : --
Unit : -
Port : --
Unit : -
Port : --
Trunk ID : 1
[Add] [Delete]
<OK>
Group 2
5,6,7,8,
17,18,19,20
3 4
Unit : - Unit : -
Port : -- Port : --
Unit : - Unit : -
Port : -- Port : --
Unit : - Unit : -
Port : -- Port : --
Member Unit : 1
Member Port : 1
Group 3
9,10,11,12,
21,22,23,24
VH-2402S