Mini-Gbic With Lc Connector - Enterasys SecureStack B2 B2G124-24 Hardware Installation Manual

Figure 3-2

Mini-GBIC with LC Connector

Ä
Å
1 Mini-GBIC (MGBIC-LC01 or MGBIC-LC09)
,
2 Mini-GBIC top side
3 7-pin edge connector (insertion side)
Removing the Mini-GBIC
Caution: Do NOT remove a Mini-GBIC from a slot without releasing the locking tab
located under the front bottom end of the Mini-GBIC. This can damage the Mini-GBIC.
The Mini-GBIC and its host switch are sensitive to static discharges. Use an antistatic wrist
strap and observe all static precautions during this procedure. Failure to do so could result
in damaging the Mini-GBIC or host switch. Always leave the Mini-GBIC in the antistatic
bag or an equivalent antistatic container when not installed.
Precaución: NO quite el Mini-GBIC de la ranura sin antes abrir la traba ubicada en la
parte frontal del Mini-GBIC.
Si lo hace, puede dañar el Mini-GBIC, puesto que es muy sensible a las descargas de
electricidad estática, al igual que el dispositivo host. Utilice la pulsera antiestática y tome
todas las precauciones necesarias durante este procedimiento. Si no lo hace, pude dañar
el Mini-GBIC o el dispositivo host. Mientras no esté instalado, mantenga el Mini-GBIC en
su bolsa antiestática o en cualquier otro recipiente antiestático.
To remove a Mini‐GBIC from a
proceed as follows:
1. Attach your antistatic wrist strap (refer to the instructions in your antistatic wrist
strap package) before removing the Mini‐GBIC.
2. Remove the cables connected to the Mini‐GBIC.
Á
Â
À
port slot, refer back to Figure 3‐1 and Figure
Installing Optional Mini-GBICs
Ã
4 Port slot
5 Protective dust cover
6 Release tab
SecureStack B2 Installation Guide
3‐2, and
3-5