About This Guide; Who Should Use This Guide - Enterasys SecureStack B2 B2G124-24 Hardware Installation Manual

This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys
stackable Ethernet switches.
For information about the Command Line Interface (CLI) set of commands used to
configure and manage the switches, refer to the Enterasys Networks
Configuration Guide.
Depending on the firmware version used in the B2G124-24, B2G124-48, and B2H124-48 switches,
some features described in this document may not be supported. Refer to the Release Notes
shipped with the switch to determine which features are supported.

Who Should Use This Guide

This guide is intended for a network administrator responsible for installing and setting
up the stackable switches.
Note: In this guide, the following terms are used:
• Switch refers to all three switches (B2G124-24, B2G124-48, and B2H124-48
otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.

About This Guide

®
SecureStack B2G124‐24, B2G124‐48, and B2H124‐48
Important Notice
®
SecureStack B2
SecureStack B2 Installation Guide
unless
)
xv