B2H124-48; B2H124-48 Stackable Switch - Enterasys SecureStack B2 B2G124-24 Hardware Installation Manual

Overview

B2H124-48

The B2H124‐48
• RJ45 ports (10/100 Mbps 100BASE‐TX copper ports).
• SFP slots that provide you with the option of installing Small Form Pluggable (SFP)
Mini‐GBICs for 1000BASE‐SX/LX fiber‐optic connections and 1000BASE‐T copper
connections.
• Rear panel connectors for high‐speed connections in a stack configuration.
• Rear panel Redundant Power Supply connector for a connection to a SecureStack
C2RPS‐SYS power supply system using the appropriate cable (C2RPS‐PSM).
The 10/100 Mbps fixed front panel ports can operate in either half‐duplex or full‐duplex
mode, as determined by Auto‐Negotiation.
Figure 1-3
Á
1 DB9 RS232 console port connector
2 Status LEDs
3 Forty-eight RJ45, 10/100 Mbps ports
4 RJ45 port status LED
5 Four slots for SFP interface modules
(Mini-GBICs)
1-4 Introduction
(Figure 1‐3) has the following front and rear panel port connections:
Caution: The B2G124-24, B2G124-48 and B2H124-48 are not PoE-compliant devices.
Do not connect a SecureStack C2 PoE Redundant Power System (C2RPS-POE) to the
power connector. Otherwise, damage to the device may result.
Precaución: Los dispositivos B2G124-24, B2G124-48 y B2H124-48 no cumplen con el
estándar PoE (power over ethernet). No conecte una fuente de poder redundante (RPS)
SecureStack C2 PoE (C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo
puede dañarse.

B2H124-48 Stackable Switch

Æ Ç
S
Ã
Â
È
6 Mini-GBIC port status LEDs
7 Two ports for stack connections
8 Reset switch
9 AC power input connector
10 Connection for a C2RPS-SYS redundant
power supply
Å
Ä À
É