Chassis Bottom, Rubber Feet Placement - Enterasys SecureStack B2 B2G124-24 Hardware Installation Manual

Figure 3-3

Chassis Bottom, Rubber Feet Placement

Â
Â
1 Bottom of chassis as seen when chassis is
resting on its back
2 Locations to install the rubber feet (four locations)
4. Remove the protective strip from the back of one rubber foot and position it on a
marked location and press firmly into place. Repeat this procedure to install the
remaining three rubber feet in the other three locations.
5. After installing the rubber feet, return the switch to its upright position.
Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to
install the rubber feet on each switch before continuing with the installation.
6. Proceed to "Guidelines for Flat Surface Installation" on page 3‐8. For a rackmount
installation, proceed to "Rack Mounting the Switch" on page 3‐9.
À
Á
Installing the Switch on a Flat Surface
Â
Â
3 Rubber feet with adhesive backing
(four)
SecureStack B2 Installation Guide 3-7