Table of Contents
Advertisement
Configuring Bridge MIB Extensions
Parameter
Extended Multicast Filtering
Services
Traffic Classes
Static Entry Individual Port
Configurable PVID Tagging
Local VLAN Capable
VLAN Learning
Auto VLAN Backplane
Configuration
Host VLAN ID
7-24
Device Control Menu Screens
Description
Indicates if the filtering of individual multicast addresses
based on Multicast Registration Protocol is active.
NOTE: This function is not available for the current
firmware release.
Indicates if the mapping of user priorities to multiple traffic
classes function is active. (For configuration information,
refer to
Section
7.10.)
Indicates if the static filtering for unicast and multicast
addresses function is active. (For configuration information,
refer to
Section
7.16.)
Allows you to override the default PVID setting (Port
VLAN ID used in frame tags) and its egress status
(VLAN-Tagged or Untagged) on each port. For details, refer
to
Section
7.15.
This switch does not support multiple local bridges (that is,
multiple Spanning Trees).
Allows you to select the VLAN Learning mode (IVL or
SVL) used by the switch.
IVL (Independent VLAN Mode) – Allows addresses to
be learned per VLAN.
SVL (Shared VLAN Mode) – Allows a single address for
all VLANs.
Enables or disables the ports on the backplane to support
automatic configuration of VLANs. The default is Enabled.
When set to Disabled, you must configure VLANs
manually. For information on how to configure VLANs
manually, refer to
Section
Allows you to enter the Host VLAN ID and it is not limited
to the default VLAN (1).
7.15.
Advertisement
Table of Contents
