Table of Contents
Advertisement
Telnet Connections
2.2
TELNET CONNECTIONS
Prior to accessing a module via a network connection, you must first configure the module with a
valid IP address, subnet mask, and default gateway using an out-of-band connection or the BOOTP
protocol.
Once the switch module is configured, you can establish a Telnet session from any TCP/IP based
node on the network. Telnet connections to the switch module require the community name
passwords assigned in the SNMP Configuration screen.
For information about setting the IP address, refer to
Chapter
6.
For information about assigning community names, refer to
Chapter
6.
Refer to the instructions included with the Telnet application for information about establishing a
Telnet session.
2-4
Local Management Requirements
Advertisement
Table of Contents
