GE Monogram ZBD6400 Owner's Manual page 27

Questions?
Use this
prob#m
sol.el"
PROBLEM POSSIBLE CAUSE WHAT TO DO
Dishwasher won't start
All cycle status
indicators flashing or
beeping every 30
seconds (on ZBD6400,
ZBD6500, ZBD6700,
ZBD6900, ZBD7000
and ZBD7100)
Motor starts but
water doesn't enter
dishwasher (flashing
CHINA CRYSTAL or
LIGHT WASH light)
(on models ZBD6400,
ZBD6500, ZBD6700,
ZBD6900, ZBD7000
and ZBD7100)
Progrmn taking too
long or not advancing
properly
Water does not empty
out of dishwasher
(flashing RINSE
ONLY or SANI WASH
light) (on models
ZBD6400, ZBD6500,
ZBD6700, ZBD6900,
ZBD7000 and
ZBD7100)
Door not properly closed • Press door until it clicks shut.
Door opened during cycle • Re-latch door. _'ait a ti_w minutes.
when water is hot Dishwasher will restart automatically.
Child I,ockout mode is • Press and hold desired button fi)r two
selected seconds. See Child I,ockout mode section
fi_r models ZBD6400, ZBD6500, ZBD6700,
ZBD6900, ZBD7000 and ZBD7100.
Power supply not • Check dishwasher is plugged in and switch
connected is ois.
Door not properly closed • Press door until it clicks shut.
Dishwasher is paused • To restart the wash cycle press the
selected wash button.
Water supply xalxe
tin'ned off
• Open water sui)pl ) wflxe.
I,ow inlet water
temperature
Outlet blocked
Run tap until water is hot prior to starting
dishwasher cycle.
Allow time to heat water (ll I) to one hour).
Check inlet water temperature,
Connect to hot water suI)ply.
Check garbage disposal and air gap fin.
blockage.
Check outlet hose fin" kinks and sharp
bends.
Dishwasher continues Faulty fill wove • Fi_t, tm'n off water sui)ply \zflve; then tm'n
to drain indefinitely off circuit breaker and call fl_r service.
Yellow color on dishes • A special filter in the water sui)ply line
and glassware is tile only way to correct this problem.
Contact a water sottener company.
White fihn on glasses, • TI T progressively increasing tile Rinse Aid
tea, and coffee stains setting to 6. See tile Rinse Agent section.
Brown spots or pitting
of stainless steel and
tanfishhlg of silver
Light goes out
X_'ater has iron or other
inineral content
Hard water
Repeated use of SAN]
Consistently low water
level in dishwasher
Discontinue use of SAN] option.
Check operating water level is between
tile MIN. and MAX. indicators on lower
spray arm sui)port towel'. See (]are and
Cleaning section.
Electrol)sis following • Wash scratched or x_orn pieces by hand.
contact with other metals Polish silxerware with a silxe>plate cleaner.
Deteroent
thi'own o_,er tile •
cutlery or
sa tlCel)ans
i,oad detergent properly. See Using the
Dishx_asher section.
• Call for set\ice.
27