GE Monogram ZBD6400 Owner's Manual page 21

Removing
and Cleaning
the Spray
Arms and
Glass 7}ap
Periodically remo_e and clean the spray re'ms
to make sure that none of the nozzles ha_e
become blocked.
To remove the lower spray arm, grasp the
center of the spray arm and pull upwards, it
will uI_clip. When tel)lacing, inake sure the
spray arm is flfllv seated and spins.
The plastic cone on the underside of the spray
am_ can be detached by unscrewing it
counterclockwise.
To remove the upper spray arm, careflfllv
tmscrew the spray arm fl'om the plastic tower.
To achieve this, hold the ironer tower steadv
and tmscrew the spray arm clockwise. To
replace the spray arm, careflfllv screw the spray
am/ counterclockwise onto the inner tower.
To clean the ui)per and lower spray arms, rinse
them trader Hmning water and make sure
spray nozzles are clear.
The glass trap is located in the stainless steel
filter at the base of wmr dishwasher. The glass
trap is used to collect larger fl)od itelns and
other tm'eign objects, which may be too big to
pass through the drain immp. For best wash
perfln'mance, check the glass trap occasionally:
To remove the glass trap, twist counterclockwise,
rotate the glass trap and lift. To clean the glass
trap, elni) V and rinse thoroughly. To replace,
revei.'se these
steps making
sure the
glass trap
locks into place.
Pull up to remove
remove cone
/:i:¢',
Rotate counterclockwise
and lift to remove glass trap
21