GE Monogram ZBD6400 Owner's Manual page 22

re and (;leaning
Dishwasher
The Wash
Filt s
In addition to the glass trap, your dishwasher
has three fine filters--
• a two piece round perfi_rated stainless steel
filter located in the base of the dishwasher.
• a finer micro-mesh filter located under the
stainless steel filter.
• a super fine filter located below the lower
spray am/.
Remove the stainless steel filter bv first twisting
and removing the glass trap. I,it* out the
stainless steel filter.
Attached to the underside of this filter is the
uficro-mesh filter. To remove the micro-mesh
filter, squeeze the two clips above the stainless
steel filter to release the micro-mesh.
To remove the super fine filter, remove the
lower spray arm. Grasp the super fine filter
around the outer edges. Remove by pulling
upwards, it will unclii). Unscrew the tower
counterclockwise. The right half of the stainless
steel filter can now be removed.
To cleml filters, place under _unning water
and gently brash with a solt bristled brush.
Be carefifl not to deflmn filters while cleaning,
as this may prevent them fl'om being properly
re-installed.
The super fine filter is self-clemfing, there is
no need to clean it. This filter need only be
removed if you want to remove the right half
of the stainless steel filter.
Replace your filters in the reverse order;
starting with the right half of the stainless
steel filter. Then screw in the tower. Replace
the super fine filter over the tower by pressing
firmly on the outer edge until it clips into
place and reposition the lower spray arm.
Reconnect the micro-mesh filter to the lett
half of the stainless steel filter prior to
replacing it back into the dishwasher, Then
replace the glass trap. Ensm'e that all filters are
replaced correctly for best results.
Grip filter and lift
to remove
Perforated sta_
steel filter
x-,___ Micro-mesh filter
Squeezeclips to remove
micro-mesh filter
Pull super fine
filter up to remove
Lift stainless steel
filter to remove
22