GE Monogram ZBD6400 Owner's Manual page 11

Operation -- ZBD6600
l) is k w a s k er
Start a
wash load
To start the dishwasher, close the door until it locks in place. To start the last selected cycle, press
the START button. To select a different cycle, turn the knobs to the desired _,\;&_SH CY(:I,E and
HEAT OPTIONS and press the START button.
NOTE: Not all heat options axe available for all cycles. If a combination that is not available is
selected, the lights will flash when the START button is pressed mad the cycle will not start.
HEAT OPTIONS
SANITIZE
NORMAI, HIGH (INCI,UDES
& HEAT HIGH TEMP & HEATED
Wash Cycles NORMAl, DRY TEMP HEAT DRY DRY)
POTS & PANS ¢" ¢" ¢" ¢" ¢"
NORMAI, WASH
CHINA CRYSTAI,
SPEED WASH
RINSE ONI,Y
,/ ,/
To interrupt/pause a cycle gently open the door just enough to tm'n off the wash Inotor Do not
flflly open the door tmtil the wash action ceases.
1_ CAUTION: Be careflfl when opening the door; the hot steam that escapes when the door is
opened may cause ii_juries. Stand back as you open the door and allow the steam
to escape.
ATTENTION : Faites attention lorsque xous omrez la porte, i,a xapeur brfllante qui
s'&hapi)e lorsque vous ouvrez la porte pendant tm programme de lavage peut
causer des brfihu'es. I,orsque wins ouw'ez la porte, reculez et laissez la vapem"
s'0chai)per de l'appareil.
To restart the wash process, close the door until it locks in place. There may be a time delay of
up to a ti_w minutes because the temperature inside your dishwasher needs to stabilize befi)re it
restarts the wash cycle.
To cm_cel the cycle after it has started, press and hold the START/CANCEI, button fl)r 3 seconds.
The dishwasher will start to drain and the cycle indicator lights will flash. At this point a new wash
cycle can be selected. If a new cycle is not selected, all the Cycle Indicator lights will go out after
the dishwasher drains completely. If wm have selected a new wash cycle, remember to add more
detergent to the detergent compartment if required.
11