GE Monogram ZBD6400 Owner's Manual page 25

Questions?
Use this
prob#m
solT)eT"
PROBLEM POSSIBLE CAUSE WHAT TO DO
Suds in the tub Correct deteroent
V_r_IS IlO[
used
Dishes mad flatware
not cleml
Too IIIHch
rinse agent used •
hnproper rack loading •
• Use only autonmtic dishwasher detelgents
to avoid sudsing.
• To remove suds fl'om tile tub, open the
dishwasher and let suds e\_q)orate. Add
1 galhm of cold water to the tub.
For 7000 series models:
• Pump out water by pressing the
NORMAI, _'\;_SH button; then press the
START/(2;XNCEI, button.
• Close the door tmtil it locks into place.
• Wait ti)r one minute; then careflflly
open the door and hold down the
START/(2_NCEI, button fiw three seconds.
For all other models:
• Pump out water by closing the door tmtil it
locks into place.
• Press the NORMAI, _'\_SH button; then
press the START/(2_NCEI, button.
• Wait lot one minute; then press and hold
down the START/(2_NCEI, button ti)r
three seconds. Repeat if necessary.
Remove any spilled rinse aid.
Reduce rinse aid setting.
For sott wateL _inse aid may be mmecessary.
Make sure large dishware does not block
the detergent dispenser or the wash arm.
• Assm'e silverware is not blocking spray
_1 fill,
Filter or spray arms dirty •
Inlet water temperature is •
below 120°F
Clean filters and spray arms according to
instructions on page 22.
Rtm tap tmtil water is hot, prior to starting
dishwasher cycle,
• Raise the water heater temperatm'e to
190°F.
• Depending on model, use X4CTER TEMP
HIGH or WATER TEMP SANI option if
suitable for dish load.
Air I ga ) is clogged *
Water pressm'e is •
temporarily low
Clean the air gap.
TtlI'II oil a [_ltlcet. Is water coilliilg o/it
more slowly than usual? If so, wait tmtil
pressm'e is normal before using yore"
dishwasher,
25