Lamp Indicator - Epson EMP-715 Owner's Manual

Indicator Status
Blinking in Warm-up in
Green progress
Blinking in Red Internal error
Extinguished The power is not
switched on

Lamp Indicator

Indicator Status
Illuminated in Time to replace the
red lamp.
Blinking in Red Lamp error
Blinking in Nearing the time
Orange for replacing the
lamp
Extinguished
Cause
(Not an error)
· Wait for a moment.
· The green lamp will stop blinking and
become illuminated once the warm-up
procedure has been completed.
Cease operations, remove the Power Plug from
the socket and contact your dealer or nearest
address provided at page 121 and request
repairs.
The power is not switched on.
· Check the power cord connection.
· Check the power supply to the socket.
Cause
Replace the lamp with a new one (ELPLP14).
· Replace with a new lamp (ELPLP14).
· Check to ensure that the lamp or fan are
correctly attached if the lamp has been
replaced. If the lamp or fan are not correctly
attached, the projector will assume the same
status as if the power has not been switched
on.
· If the lamp is broken, take care to avoid injury
and contact your nearest address provided at
page 121 to request repairs (images cannot be
projected unless the lamp is replaced).
Prepare a new lamp. It is recommended that
the lamp is replaced as soon as possible, as
there are cases where the time for replacement
is earlier than stated in the conditions of usage.
(Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Recovery or Status
Recovery and Status
Reference
Page
37
36
Reference
Page
111
111
Troubleshooting - 97