Lamp Or Temp Indicator Flashes Orange - Epson EMP-S4 User Manual

Problems Solving

Lamp or Temp indicator flashes orange

Status
High temperature warning
Power Red
Orange
Lamp replacement notification
Power
Orange
• If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No
Help" on the following page.
• If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided in
the "International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
Warning
Cause
(This is not an abnormality, but if the temperature rises too high again, projection will stop
automatically.)
•Check that the air filters and air exhaust vent are clear and that they are not up against a surface
such as a wall.
•If the air filters are clogged, clean or replace them. sp.56,
Replace the lamp with a new one.
If you continue to use the lamp after it has passed the replacement period, the possibility that the
lamp may break will increase. Replace the lamp with a new one as soon as possible. The Power
indicator status will vary depending on the projector status at the time.
Remedy or Status
p.62
sp.59
45
: lit : flashing : off