Messages Displayed When Using The Scanner Function - Ricoh Aficio MP C3002 User Manual

Messages during Direct print from a removable memory device
Message
"99: Error"
If printing does not start, contact your service representative.
• The contents of errors may be printed on the Configuration Page. Check the Configuration Page in
conjunction with the error log. For details about how to print the Configuration Page, see "List / Test
Print", Print .

Messages Displayed When Using the Scanner Function

This section describes likely causes of and possible solutions for the error messages that appear on the
control panel. If a message not described here appears, act according to the message.
Message
"Authentication with the
destination has failed. Check
settings. To check the current
status, press [Scanned Files
Status]."
"Cannot communicate with
PC. Contact the
administrator."
Causes
This data cannot be printed.
The specified data is either
corrupt or not supported by
the Direct printing function
from removable memory
devices.
Causes
The entered user name or
password was invalid.
WSD (Device) protocol or
WSD (Scanner) protocol is
disabled.
When Messages Are Displayed on the Control Panel
Solutions
Check that the data is valid. For details
about the kinds of data supported by
the Direct printing function from
removable memory devices, see
"Direct Printing from a Removable
Memory Device", Print
Solutions
• Check that the user name and
password are correct.
• Check that the ID and password
for the destination folder are
correct.
• A password of 128 or more
characters may not be
recognized.
For details about how to enable or
disable the WSD protocol, see Security
Guide .
.
211