Network Settings With External Server Authentication; When Ssl Is Installed; Using Active Directory - Konica Minolta bizhub C650 User Manual

Network Settings
4.2

Network settings with external server authentication

In order to use an external server to perform user authentication, various settings must be specified according
to the server to be used. Specify the settings according to the procedures described below.
Specify the external server authentication settings according to the network environment being used.
Setting
Active Directory
NTLM v1
NTLM v2
NDS
LDAP
!
Detail
If "Active Directory" was selected for external server authentication, specify a password of one or more
characters. If no password is specified, authentication will fail.
Do not use """ or "+" in the external server password. For details on the operating conditions of the
external server, contact the network administrator.
If "Password Rules" is set to "Enable", only a password with 8 digits can be specified. For details on
the password rules, refer to the User's Guide [Copy Operations].
A maximum of 20 external servers can be registered.
If external server authentication was selected, [Server Name] appears in the user authentication screen
so that logon is possible by selecting a server from those that are registered.
Note
The specifications of the operating system may have changed, or a new operating system may have
been released. For details, refer to the manual for the operating system.

When SSL is installed

If external server authentication is specified while SSL is installed, "TCP Socket Settings" changes to "Screen
of the SSL Settings". After specifying settings for external server authentication, be sure to turn the machine
off, then on again.

Using Active Directory

Before performing the operation, make sure that the following information is available.
- Administrator password (required)
- IP address of this machine (required)
- Subnet mask (required)
- Default gateway
- Priority DNS server address (required)
- Alternate DNS server address 1
- Alternate DNS server address 2
- Default DNS domain name
- DNS host name
- Default domain name for Active Directory (required)
- IP address of the NTP server (time adjustment)
- List of users for authentication (required)
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the Administrator
Settings screen" on page 3-5.
C650
Description (reference)
Select this setting when using Window 2000 Server or 2003 Server.
Select this setting when using Window NT 4.0 Server.
NTLMv2 is applied from Windows NT 4.0 (Service Pack 4).
Select this setting when using NetWare 5.1 or NetWare 6.0.
Select this setting when using an LDAP server.
4
4-3