Confirming That The Original Is Scanned (Tx Stamp); Tx Stamp - Konica Minolta bizhub C451 User Manual

Useful transmission functions
6.8

Confirming that the original is scanned (TX Stamp)

TX Stamp

When the fax is to be sent using ADF, whether each page of the original has
been scanned or not can be confirmed by adding the completion stamp to
the scanned original. A 4 mm (1/4 inch) diameter pink colored -
added on the bottom edge of the front side of the original. When a duplex is
to be sent, the stamp is added on the front side.
Note
In order to use the TX Stamp function, optional stamp unit must be in-
stalled.
The stamp ink is a consumable commodity. When the stamping becomes
light, contact your technical representative.
When a mixed original is selected, the completion stamp may not be
stamped on the above-mentioned position.
Even if completion stamp setting is specified, the completion stamp may
not be added if the original sending is multiplexed, etc. Send the original
once again.
Check whether the original has been correctly faxed or not from the
transmission result report and the transmission report of settings confir-
mation screen.
If the completion stamp function is used while Quick Memory TX is se-
lected, the Quick Memory TX is cancelled and it changes memory trans-
mission.
C451
Front surface of original
Original transmitting
direction
6
stamp is
Stamp
position
6-30