Table of Contents
Advertisement
Remote control
Changing the frequency of remote control signal
The accessory remote control has the two choices on signal
frequency Mode 1:NORMAL and Mode 2:HIGH. If the remote
control does not function properly, attempt to change the signal
frequency.
In order to set the Mode, please keep pressing the
combination of two buttons listed below simultaneously for
about 3 seconds.
(1) Set to Mode 1:NORMAL... VOLUME - and RESET buttons
(2) Set to Mode 2:HIGH... MAGNIFY OFF and ESC buttons
Please remember that the REMOTE FREQ. in the SERVICE
item of the OPTION menu (42) of the projector to be
controlled should be set to the same mode as the remote
control.
Using as a simple PC mouse & keyboard
The enclosed remote control works as a simple mouse and
keyboard of the PC, when the projector's USB port (B type)
connects with the PC's mouse port via a mouse cable.
(1) PAGE UP key: Press the PAGE UP button.
(2) PAGE DOWN key: Press the PAGE DOWN button.
(3) Mouse left button: Press the ENTER button.
(4) Move pointer: Use the cursor buttons ▲, ▼, ◄ and ►.
(5) ESC key: Press the ESC button.
(6) Mouse right button: Press the RESET button.
CAUTION ►Improper use of the simple mouse
& keyboard function could damage your equipment.
While using this function, please connect this product
only to a PC. Be sure to check your PC's manuals
before connecting this product to the PC.
NOTE • When the simple mouse & keyboard function of this product does not work
correctly, please check the following.
- When the mouse cable connects this projector with a PC having a built-in pointing
device (e.g. track ball) like a notebook PC, open BIOS setup menu, then select the
external mouse and disable the built-in pointing device, because the built-in pointing
device may have priority to this function.
- Windows 95 OSR 2.1 or higher is required for this function. And also this function may
not work depending on the PC's configurations and mouse drivers.
- You cannot do things like press two buttons at once (for instance, pressing two buttons
at the same time to move the mouse pointer diagonally).
- This function is activated only when the projector is working properly. This function
is not available while the lamp is warming up (the POWER indicator flashes green),
and while adjusting the volume and display, correcting for keystone, zooming in on the
screen, using the BLANK function, or displaying the menu screen.
MY SOURCE/
VIDEO
COMPUTER
DOC.CAMERA
ASPECT
AUTO
SEARCH
BLANK
FREEZE
PAGE
VOLUME
MAGNIFY
UP
ON
DOWN
OFF
(2)
KEYSTONE
MY BUTTON
MUTE
1
2
MENU
POSITION
ENTER
ESC
RESET
USB port
USB
MY SOURCE/
VIDEO
COMPUTER
DOC.CAMERA
AUTO
ASPECT
SEARCH
BLANK
MAGNIFY
FREEZE
PAGE
VOLUME
UP
ON
DOWN
OFF
KEYSTONE
MY BUTTON
MUTE
1
2
(3)
POSITION
MENU
ENTER
ESC
RESET
(5)
(1)
(1)
(2)
(4)
(6)
Advertisement
Table of Contents
