About The Remote Control Signal; Changing The Frequency Of Remote Control Signal - Dukane 8931WA User Manual

About the remote control signal

The remote control works with the projector's remote
sensor. This projector has a remote sensor on the front.
The sensor senses the signal within the following range
when the sensor is active:
60 degrees (30 degrees to the left and right of the sensor)
within 3 meters about.
NOTE
• The remote control signal refl ected in the screen or the like may be available.
If it is diffi cult to send the signal to the sensor directly, attempt to make the signal refl ect.
• The remote control uses infrared light to send signals to the projector (Class 1
LED), so be sure to use the remote control in an area free from obstacles that
could block the remote control's signal to the projector.
• The remote control may not work correctly if strong light (such as direct sun
light) or light from an extremely close range (such as from an inverter fl uorescent
lamp) shines on the remote sensor of the projector. Adjust the position of
projector avoiding those lights.

Changing the frequency of remote control signal

The accessory remote control has the two choices on signal
frequency Mode 1:NORMAL and Mode 2:HIGH. If the remote control
does not function properly, attempt to change the signal frequency.
In order to set the Mode, please keep pressing the combination of
two buttons listed below simultaneously for about 3 seconds.
(1) Set to Mode 1:NORMAL... VOLUME - and RESET buttons
(2) Set to Mode 2:HIGH... MAGNIFY OFF and ESC buttons
Please remember that the REMOTE FREQ. in the SERVICE item of
the OPTION menu (62) of the projector to be controlled should be
set to the same mode as the remote control.
Remote control
(approx.)
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO
SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
OFF DOWN
(2)
MY BUTTON
KEYSTONE MUTE
POSITION MENU
ENTER
ESC RESET
(1)
19