Emerson Network Router User Manual page 48

Initial Transmitter Startup Procedures
Figure 4-4
4. Change the
transmitter before performing the actual zeroing procedure.
5. If the Convergence Limit parameter is displayed, type a new convergence limit in the
Converg. Limit
6. Click
light will turn red.
7. Wait until the zero time has expired. At the end of this time:
• If the
-
-
Note: These two functions are not available on all transmitters.
• If the
status light does not turn red, the zero procedure succeeded.
8. Click
42
Zeroing
if necessary. You will need to click
Zero Time
box or accept the default value.
. The meter will begin zeroing. The
Perform Auto Zero
Calibration Failure
See your transmitter manual for troubleshooting procedures.
If desired, use the buttons in the dialog box to restore the previous zero value or the
zero value established during factory calibration.
Calibration in Progress
.
Close
status light turns red, the zero procedure failed.
status light returns to green and the
ProLink
to send the new value to the
Apply
Calibration in Progress
Calibration Failure
®
II Software for Micro Motion
status
®
Transmitters