8. Printing Procedures - Mitsubishi CP700E Operation Manual

Colour video copy processor
Table of Contents

Advertisement

8. Printing Procedures (Special prints)
SET
B Press the SET
, The source image (image from the input signal) is displayed.
1 Storing images in memory / Printing the images
1 Store the images to be printed in memory.
, Refer to 1 MULTI PRINT or 2 PHOTO PRINT for storing images in memory.
2 Press the PRINT button.
, The set SEPARATE images are printed.
Note :
, The distance between images in multi-print is different between on the monitor and the printed image.
, The image size changes according to the "SIZE" in "6. SYSTEM MENU".
When the images of different size are memorized in one page, the margin is determined according to the largest width of the
image in the page.
4 STROBE PRINTS
1 OPERATION
1 Selecting FIELD or FRAME
1 Setting STROBE function
1 Press the MENU button. Then press the UP
2 Press the RIGHT
3 Press the UP
4 Press the RIGHT
, Each time the RIGHT
, The interval of memorization can be set as follows:
, 1/13 sec • 1/5 sec • 1/2.5 sec • 1 sec • 2 sec • 5sec • 10 sec • 30 sec ..... every second
, 1 min • 2 min • 5min • 10min • 30 min ...................................................................... every minute
, 1hr ................................................................................................................................................ every hour
, Images can not be memorized during printing while images are fully stored in memory page.
When the interval of the strobe time is a value lower than the automatic capture and print time interval, the printer will not be
able to the image because print time is longer than strobe time. Adjust strobe time by selecting a higher value.
(Example : interval of 10 seconds or less in FIELD mode and interval of 30 seconds or less in FRAME mode)
76
button.
button to select "3. ADDITIONAL".
button to select "STROBE : OFF"
button to select "STROBE : 1/13 .... 1hr".
or LEFT
button is pressed, the interval of image memorization is switched.
or DOWN
button to select "3. ADDITIONAL PUSH [
]".

Advertisement

Table of Contents
loading

Table of Contents