Mitsubishi CP700E Operation Manual page 20

4. Connection with external equipment (RS-232C Interface)
4 Connection with RS-232C equipment
, When connecting the unit with another equipment, make sure to set the power of each equipment to "OFF".
To RS-232C port
Equipment with RS-232C
Setting BAUD RATE
Set the baud rate of this unit according to the equipment to be connected.
, As to the baud rate of the equipment connected, refer to the operation manual of the equipment connected.
Displaying the menu screen
, The baud rate is set on the menu displayed on the monitor screen or LCD. (The following is an example of display on LCD.)
, Make sure to turn off the power before setting.
Displaying "Memory SW
1 Press the POWER button while pressing the MEMORY button on the
front panel.
, The menu for memory switch, "Memory SW Main Menu" is displayed.
Displaying "System Set Menu"
} Use the buttons on the remote control to display and set this menu.
2 Press the DOWN button to select "5. SYSTEM SET : PUSH
[ ] ]" .
3 Press the RIGHT button.
, The menu for signal setting, "System Set Menu" is displayed.
, Set "BAUD RATE" on this menu.
Main Menu"
To RS-232C port
(RS-232C)
1
RS-232C REMOTE
VIDEO
S-VIDEO
IMPEDANCE
RGB
R G/G+SYNC B H+V-SYNC
IN
SYNC.
OUT
R G/G+SYNC B H+V-SYNC
VCP
M e m o r y S W M a i n M e n u
1 . T I M E A D J : P U S H [ > ]
M e m o r y S W M a i n M e n u
5 . S Y S T E M S E T : P U S H [ > ]
S y s t e m S e t M e n u
P R G A L L I N I T : O F F
2
AC LINE
75
HIGH
75
HIGH
19