7. Setting The Functions - Mitsubishi CP700E Operation Manual

7. Setting the functions (Main menu)
ANALOG ADJ The adjustment image of analog input signal display
, This menu is used to adjust the image of analog input signal display before storing in the memory.
, This menu is opened when pressing RIGHT
, When selecting RGB analog signal, "COLOR" "TINT" is not adjusted and displayed.
BRT (Bright )
Function
CONT (Contrast )
Function
R-SUB (Red-subcontrast)
Function
B-SUB (Blue-subcontrast)
Function
C O L O R
Function
, The each function and setting area is as follows.
Item
B R T
C O N T
R-SUB
B-SUB
C O L O R
• When selecting the RGB signal, COLOR is not shown on the monitor display.
C E N T E R
Function
, When pressing the SET
"1.COLOR ADJ" menu is displayed.
46
Adjust the brightness of printing image.
Adjust the contrast of printing image.
Adjust the red-subcontrast of printing image.
Adjust the blue-subcontrast of printing image.
Adjust the color of printing image
Adjustment
Brightness
Contrast
Red-subcontrast
Blue-subcontrast
Color
The setting value of "COLOR ADJ" is initialized.
When this function is set to "ON" , the setting value of BRT, CONT, R-SUB , B-SUB, COLOR is reset to 0.
SET
button after selecting "OK" on the lower position "CHANGE : OK/CANCEL" ,
button on "ANALOG ADJ : PUSH [ ] ]" .
-32 Adjusting area
Darker ............................. Brighter
Less contrast ....................... More contrast
Add cyan ........................... Add red
Add yellow ......................... Add blue
Light .............................. Deep
+31