Table of Contents
Advertisement
4. Connection with external equipment (Monitor)
Setting the output sync. signal "OUTPUT SYNC"
5 Press the DOWN
, The set level of the sync. signal, for example, "0.3V" is displayed.
Set the sync. signal according to the equipment to be connected.
Press the RIGHT
"TTL".
0.3V ...... 0.3Vp-p
TTL .... TTL level
Setting the output RGB Analog signal "RGB SOG OUT"
6 Press the DOWN
7 Press the RIGHT
OFF...... Outputs Composite Sync. signal
ON ...... Outputs Sync. On Green + Composite Sync. signal.
Select "ON" or "OFF" according to the monitor to be connected.
SET
8 Press the SET
, "CHANGE : OK/CANCEL" is selected.
Press the RIGHT
"CANCEL" .
9 Select "OK" , then press the SET
, "Memory SW Main Menu" is displayed.
SET
A Press the SET
, "CHANGE : OK" is selected.
B Select "OK" , then press the SET
, The source image (input signal from the equipment) is displayed.
0 The setting of the sync. polarity and signal is completed.
16
or UP
button to select "OUT SYNC".
or LEFT
button to select "0.3V" or
or UP
button to select "RGB SOG OUT".
or LEFT
button to select "ON" or "OFF".
button.
or LEFT
shift button to select "OK" or
SET
button.
button.
SET
button.
S i g n a l A d j M e n u
O U T S Y N C : T T L
S i g n a l A d j M e n u
R G B S O G O U T : O F F
S i g n a l A d j M e n u
C H A N G E : O K
M e m o r y S W M a i n M e n u
3 . S I G N A L A D J : P U S H [ > ]
Advertisement
Table of Contents
