Mitsubishi CP700E Operation Manual page 19

4. Connection with external equipment (RGB Analog signal)
3 Connection with RGB Analog Signal equipment
, When connecting the unit with another equipment, make sure to set the power of each equipment to "OFF".
S-VIDEO
, Use BNC type cable on the market for connection.
, This unit functions at 15.625 kHz for H and 50Hz for V.
Setting the switches
, Set the impedance switches "IMPEDANCE" on the rear panel to the impedance of the equipment connected.
Normally,
a.Set the RGB analog signal to "75 ".
b.Set the sync signal to "HIGH.
NOTE: • When the power turns off or the display is not appeared with analog through mode, the impedance switch is not
available. So, connect the unit with the side of monitor or external terminal .
• When connecting to a monitor, use the monitor with 75 .
18
To RGB Analog IN
terminal (
In case of SYNC ON G.
signal, it is not
necessary to connect to
the unit.
1
RS-232C
REMOTE
VIDEO
IMPEDANCE
RGB
R G/G+SYNC B H+V-SYNC
IN
SYNC.
OUT
R G/G+SYNC B H+V-SYNC
To RGB Analog OUT terminal
IMPEDANCE
RGB
Impedance switch for RGB analog signal
75
HIGH
SYNC.
75
Impedance switch for sync. signal
HIGH
)
VCP
2
AC LINE
75
HIGH
75
HIGH
RGB Analog signal equipment
RECORD RED CONTRAST
REPLAY GREEN GREEN BRIGHTNESS BRIGHTNESS
10 KEY BLUE BLUE
POWER
ON OFF
RESET RESET
SCAN START
SCAN SPEED
WHITE
BALANCE