Connection With External Equipment - Mitsubishi CP700E Operation Manual

4. Connection with external equipment

The functions of this unit can be set with the menu screens displayed on the monitor.
1 Connection with Monitors
Explains how to connect with a monitor.
Explains the setting of sync. polarity.
, When the sync. polarity of a monitor differs from the initial setting of this unit, the image on the monitor may not be
displayed correctly. In this case, set the sync. polarity according to the monitor.
When the image is displayed on the monitor correctly, the setting is not required.
2 Connection with VIDEO/S-VIDEO (Y/C separate VIDEO) signal equipment
Explains how to connect with a video signal equipment.
Explains how to connect with a S-video signal equipment.
3 Connection with RGB Analog Signal equipment
Explains how to connect with a RGB analog signal equipment.
4 Connection with RS-232C equipment
Explains how to connect with a RS-232C equipment.
1 Connection with Monitors
Connect this unit with a monitor to check the images to be printed and the images stored in memory.
The following example shows the connection with a video signal, a S-video signal and RGB analog signal equipment.
Connect with the necessary signal equipment.
When connecting the unit with a monitor, make sure to set the power of each equipment to "OFF" .
14
To S-VIDEO OUT terminal
S-VIDEO ( )
To S-VIDEO IN terminal
To VIDEO IN terminal
To VIDEO OUT termi nal
VIDEO ( )
1 2
RS-232C
REMOTE
VIDEO
S-VIDEO
AC LINE
IMPEDANCE
RGB
R G/G+SYNC B H+V-SYNC
75
IN
HIGH
SYNC.
75
OUT
HIGH
R G/G+SYNC B H+V-SYNC
VCP
To RGB Analog IN
terminals
To RGB Analog OUT
terminals (
Monitor
)
Pages 14 - 16
Page 17
Page 18
Pages 19 - 21