Pedal Support Arm & Pivoting Arm Assembly; Front Decoration Cover Assembly - Smooth Fitness CE-8.0LC Owner's Manual

"A
I
SSEMBLY NSTRUCTIONS"
Note:
make sure the bolts are fully tightened to avoid noise
S –
TEP 8

Front Decoration Cover Assembly

d. Slide the Upright Sleeve (22) down to cover the open area of the Main Frame (1).
S
TEP 7
& Pivoting Arm Assembly
a. Attach the Left Pedal Support Arm
(10) onto the Left Pivoting Arm (8)
and secure with the 1x Button Head
Bolt (M10xp1.5x85mm) (90) and 1 x
Nylon lock Nut (M10xp1.5) (104).
b. Press the Nut Cap (105) onto the
Nylon lock Nut (M10xp1.5) (104).
c. Repeat the above procedure to attach
the Right Pedal Support Arm (11)
onto the Right Pivoting Arm (9).
NOTE: Please make sure Bolts (90) are
inserted from the inside of the Pivoting Arm
and the Nuts (104) and Nut Caps (105) are
installed from the outside
a. Please go back to fully tighten with the 2 x
Hex Head Bolts
(M10xp1.5x50mm)
(95) and the 2 x
Lock nuts (103)
with the T-Handle
SOCKET WRENCH
(17mm) as shown.
b. Attach the Front Decorative Upright
Cover (21) onto the front of the Main
Frame (1) with the 2 x Round Head
Screws (M5xp0.8x50mm) (81).
c. Place the Logo Sticker on the surface of the
Front Decorative Upright Cover (21).

7
–
Pedal Support Arm
A logo sticker is located in one of the
hardware boxes.