Displaying The Picture - Hitachi CP-X2011N Operating Manual

Displaying the picture

Activate your signal source. Turn the signal
1.
source on, and make it send the signal to
the projector.
2. Use the VOLUME + / VOLUME - buttons
to adjust the volume.
To have the projector silent, press the MUTE
button on the remote control.
3. Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from the
HDMI, COMPONENT (Y, Cb/Pb, Cr/Pr),
S-VIDEO or VIDEO port, or the COMPUTER
button for selecting an input signal from the
COMPUTER IN1, COMPUTER IN2, LAN,
USB TYPE A or USB TYPE B port.
4. Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
5. Use the zoom ring to adjust the screen
size.
6. Use the focus ring to focus the picture.
CAUTION ►If you wish to have a blank screen while the projector's lamp is
on, use one of methods below.
- Use the supplied lens cover.
- Use the BLANK function (see "Operating Guide").
Taking any other action may cause the damage on the projector.
NOTE • The ASPECT button does not work when no proper signal is inputted.
• For the details of how to adjust the picture, please see "Operating Guide".
17, 19)
(
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
VOLUME+ button
ON
DOWN
VOLUME- button
OFF
KEYSTONE MY BUTTON MUTE
1 2 MUTE button
POSITION MENU
ENTER
RESET
ESC
INPUT button
VIDEO button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
COMPUTER button
ASPECT AUTO SEARCH BLANK
FREEZE PAGE VOLUME
MAGNIFY
UP
ON
ASPECT button
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
MENU
POSITION
ENTER
ESC RESET
Zoom ring
Focus ring
11