Monitor Out - Hitachi CP-X2011N Operating Manual

Item
ECO MODE
MIRROR
STANDBY MODE

MONITOR OUT

Using the ▲/▼ buttons turns off/on the Eco mode.
NORMAL ECO
• When the ECO is selected, acoustic noise and screen brightness
are reduced.
• When AUTO ECO MODE (
always be set to Eco mode at start-up regardless this setting.
Using the ▲/▼ buttons switches the mode for mirror status.
NORMAL H:INVERT
If the Transition Detector is on and MIRROR status is changed,
TRANSITION DETECTOR ON alarm (
projector is restarted after the AC power is turned off.
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL SAVING
When SAVING is selected, the power consumption in the standby
mode is lowered with some functional restriction as below:
• When SAVING is selected, the RS-232C communication control
except to turn the projector on and the network function are disabled
while the projector is in the standby mode. If the COMMUNICATION
TYPE in the COMMUNICATION menu is set to NETWORK
BRIDGE, all of the RS-232C commands are disabled (
• When SAVING is selected, STANDBY setting of AUDIO SOURCE
42) is invalid, and no signal is output from AUDIO OUT port in
(
the standby mode.
While the image signal from the input port chosen in step (1) is
projected, the image signal from the input port selected in step (2) is
output to MONITOR OUT port.
(1) Choose a picture input port using ▲/▼ buttons.
Choose STANDBY to select the picture
output in the standby mode.
(2) Select one of the COMPUTER IN ports
using ◄/► buttons.
Select OFF to disable the MONITOR OUT
port for the input port or standby mode
chosen in the step (1).
• You cannot select COMPUTER IN1 in step (1) and COMPUTER IN2
in step (2) and vice versa.
• If you have changed the setting of STANDBY, it applies only to
the current standby mode, NORMAL or SAVING, selected under
STANDBY MODE, without changing the setting of the other mode.
The factory settings are as follows:
- COMPUTER IN1 for the NORMAL mode of STANDBY MODE
- OFF for the SAVING mode of STANDBY MODE
Description
40) is set to ON, the projector will
V:INVERT H&V:INVERT
70) will be displayed when
SETUP menu
57).
41