Hitachi CP-X2011N Operating Manual page 137

1. Connection to the network
1.7 Conguring the network settings manually (continued)
If you need to add a Network conguration on your computer to connect to the
projector.
This dialog will be displayed when you
need to add a Network conguration on
your computer to connect to the projector.
Conrm with your network administrator if
the Network conguration displayed on the
dialog is OK, and then click the [Yes].
Click the [NO], then the "LiveViewer" main menu is displayed even though the
network is not established. Click
Selecting the network connection method. (
If you put a check mark in the box "Not displaying conrmation dialog for adding
Network settings", the projector memorizes current conguration and this dialog
is not displayed again. To display this dialog again, click Option
"LiveViewer" main menu and remove the check mark in the box "Not displaying
conrmation dialog for adding Network settings".
If you want to change the Network
conguration to add, click the [Change]. A
dialog for changing the Network conguration
as shown to the right will be displayed. Enter
IP address and subnet mask , then click the
[OK]. Procedure to connect to the projector
will start.
Proceed to item 1.8 Conrming the
connection to your destination. (
If you click the [Cancel], you will return to the
dialog for adding a Network conguration.
28
on the main menu and go back to item 1.5
14)
30)
icon in the