Removing The Cr Motor Assembly - Epson Stylus COLOR 760 Service Manual

EPSON Stylus COLOR 760

4.2.4.4 Removing the CR Motor Assembly

1. Remove the Upper Housing. (Refer to Section 4.2.1)
2) Slide the CR Lock Lever to front with tweezers or small driver and release
the CR Lock Lever from the CR unit. Then move the CR unit to the centre
area of the CR shaft.
3) Loosen the CR Timing Belt by pushing the Driven Pulley Holder to right
with the screw driver and remove the Timing Belt carefully from the pinion
gear on the CR motor. Refer to Figure 4-17.
Driven Pulley Holder
Figure 4-17. Removing the Timing Belt
4) Remove two screws (No.1) while holding the CR motor and remove the CR
motor assembly. Refer to Figure 4-18.
Disassembly and Assembly
CR Timing Belt
n
n
Disassembly Procedures
Top Frame
No.1 Screws
Figure 4-18. Removing the CR Motor Assembly
When you remove the Timing Belt from the pinion gear on
CR motor, be careful not damage the CR Encoder Slit plate.
When you remove the CR motor through the hole of the
Top Frame, be careful not contact the pinion gear to the
edge of the hole.
Revision C
CR Motor
90