Epson Stylus COLOR 760 Service Manual page 130

EPSON Stylus COLOR 760
4. Input the 10-digit-code serial number in the input menu and click the
"OK" button.
NOTE: Even though you type an irresponsible 10-digit code and
click the "OK" button, the program accepts the code and
writes it to the specific address of the EEPROM.
However, there is a possibility that the code is not unique
and conflicts with another USB ID in the USB port driver.
5. After clicking the "OK" button, you will see the following message in
the bottom column of the USB ID Check/Input menu. In this
message, you can check if the USB ID is written in the EEPROM
correctly.
Figure 5-32. Write down the USB ID
6. Click the "Previous" button to go back to the "USB ID Check/Input"
menu.
Adjustment
7. Select "Confirmation of USB port function" and click the "OK" button
in "USB ID Check/Input" menu.
Figure 5-33. Select the Confirmation of USB port function
NOTE: Above "Confirmation of USB port function" is available
only the USB port and driver are installed in the
Windows98 environment.
8. The following message appears.
The action to take hereafter varies depending on your PC's
condition. If you select "Yes", go to
Flow N.
Adjustment
Figure 5-34. Message 1
Flow Y. If you select "No", go to
Revision C
130