Epson Stylus COLOR 760 Service Manual page 146

EPSON Stylus COLOR 760
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
Oil pad in the carriage assembly
<Lubricant Type> O-12
<Lubrication Amount>
16
0.72 ~ 0.77cc (0.65 ~ 0.69g)
Note:
This is the amount to be applied to a new
oil pad.
<Lubrication Point>
Shaft for "FRAME, LEFT"
17 <Lubricant Type> G-26
<Lubrication Amount>
1 x 5mm
<Lubrication Point>
Inside of the right hole of "FRAME, ASF;
B"
18
<Lubricant Type> G-26
<Lubrication Amount>
1 x 1mm
<Lubrication Point>
Left and right edges of "HOPPER
ASSEMBLY; C"
19
<Lubricant Type> G-26
<Lubrication Amount>
2mm-diameter ball
Maintenance
Remarks / Reference Page
Lubricate the oil pad only when:
• Replacing the carriage
assembly
• Replacing the oil pad
Use a precise syringe to apply oil.
If you accidentally apply too
much oil to the oil pad, throw the
pad away and take a new one
again.
Leave the pad for a while to wait
until oil is evenly infiltrated, then
install it on the carriage
assembly.
See Page 150.
Apply grease evenly to the inside
of the hole.
Use a brush to apply grease.
See Page 150.
Use a brush to apply grease.
See Page 151.
Overview
Table 6-2. Lubrication Point (continued)
No. Standard
<Lubrication Point>
"GUIDE PLATE, CR" (the part where the
carriage slides on.)
20
<Lubricant Type> G-26
<Lubrication Amount>
1 x approx. 270mm
Revision C
Remarks / Reference Page
See Page 151.
146