Select The Model Name - Epson Stylus COLOR 760 Service Manual

EPSON Stylus COLOR 760

5.2.3.3 Select the Model Name

1. Before performing any adjustment, you need to select the model
name in the first menu. When you press the OK button after
selecting the model name, the adjustment program sends the
factory command to the printer in order to set the IEEE1284-4 mode
to OFF status. This is because this program dose not run in the
IEEE1284-4 mode.
Figure 5-10. Main menu of the this Program
Adjustment
NOTE: When the OK button is pressed in this menu, this
adjustment program dose not verify the model name stored
in the PROM.
NOTE: IEEE-1284-4 mode is reset to ON status by performing the
Hardware reset.
NOTE: When you select "About" and click it, the program version is
shown.
Adjustment
Revision C
119