Installation Of The Automatic Buttonholer; Adjusting The Working Height; Attaching The Thread Stand - Duerkopp Adler 559 Installation Instructions Manual

9.

Installation of the automatic buttonholer

9.1

Adjusting the working height

9.2

Attaching the thread stand

6
The working height is infinitely variable between 73 cm and 90 cm
(measured up to the upper edge of the table top).
–
Loosen the locking screws 1 and 2 on both sides of the stand.
–
Set the working table of the automatic buttonholer to the desired
working height.
–
Tighten the locking screws 1 and 2.
–
Insert the thread reel stand 3 in the hole of the table top and fasten
it with nuts and washers.
4
–
Mount and align the thread reel bracket 5 and the unwinding arm 3
as shown in the illustration.
Important: thread stand and unwinding arm must be positioned
3
exactly one above the other.
–
Depending on the type of thread reel the centering piece 6 must be
set as shown in the above illustration. Incorrect settings can lead to
5
sewing disturbances.
1
2
3
2
6
9