REV.-A
4.2.4.11 Platen Unit Removal
1. Remove the upper case (Refer to Section 4.2. l.).
2. Remove the two CBNS (3 X 6) screws securing the platen cover to side frames L and R, then remove
the platen cover.
Shaft Holder
Paper Holding Roller Shaft
Fig. 4-31. Platen Cover Removal
3. Push on the right shaft holder clip, and rotate it forward.
4. Remove the platen unit by moving it to the right side while pulling paper holding roller shaft forward.
Right Shaft Holder
Platen
Fig. 4-32. Platen Removal
4-26