Epson LQ-1050 Technical Manual page 161

REV.-A
4.2.4.20 Push Tractor Unit Disassembly
This section describes the removal of the tractor assembly (left). Since disassembled parts can be
reassembled by using the removal procedures in reverse orde~ assembly procedures have been
omitted.
shaft holder from the tractor mounting plate L.
Remove the
Remove the
2.
HNO (4) nut securing the tractor guide shaft.
Remove the
3.
tractor side frame L.
Remove the
4.
Push the tractor lock lever upward, and remove the left sprocket assembly from the shafts.
5.
Tractor
eft tractor frames are at the same position. Make sure that the pins on the right and left tractor belts
/
6) ~ Shaft Holder
X
Fig. 4-51. Tractor Assembly (left) Removal
v
Marks
Fig. 4-52. Tractor Assembly Phases
4-38