Cr Motor Removal - Epson DFX-8500 Service Manual

DFX-8500

3.2.6.20 CR Motor Removal

Step 1: Remove the right cover. (Refer to Section 3.2.3.2.)
Step 2: Disconnect the red and black cables from the terminals on the CR motor. (two cables for each
terminal)
Step 3: Remove the three CP(S) (M4x10) screws securing the CR motor to the right side frame and remove
the motor.
When you install the CR motor, perform the carriage timing belt tension adjustment, as described in
Section 4.1.2.
When you install the printhead, perform the platen gap motor value (platen gap) adjustment, as
described in Section 4.1.7.
3-54
Figure 3-77. CR Motor Removal
ADJUSTMENT REQUIRED
Rev. B